,....,
N
,....,
N
0
J:
'SI:
,....,
\!)
1.1'1
,....,
1.1'1
,....,
- The high beam works only when the head-
lights are on. The indicator light II in the
instrument cluster ill uminates when the
high beams are on.
- The
headlight flasher works only as long as
you hold the lever - even if there are no
lights turned on. The indicator light
II in
the instrument cluster illum inates when you
use the headlight flasher .
A WARNING
Do not use the high beam or headlight
flasher if you know t hat these could blind
oncoming t raffic.
High beam assist
Appl ies t o vehicles : wit h high beam assist
-
The high beam assist automatically switches
the high beams on or off, depending on the
surroundings and traffic conditions.
Fig. 43 Turn signa l and high beam l ever: Turning on
and off t he high beam assist
Activating high beam assist
Requirement : The light switch must be in the
AUTO position, the low beam headlights must
be on and the high beam assist must be
switched on in the I nfotainment~
page 47.
.. Press the lever forwards (D in order to acti-
vate the high beam assist. The indicator
light
IIJ turns on in the inst rument cluste r
display and the high beams switch on or off
automati cally. The indicat or ligh t
Iii turns
on if t he high beams were switched on.
Switching the high beams on/ off
manually
Requi rement : High beam assist is activated.
Clear v ision 49
If the high beams did not swit ch on/off auto -
matically when expected, you may instead
switch them on/off manually:
.. To switch the high beams on manually, press
the lever forwa rds (D . The indicato r light
Bl
turns on.
.. To switch the high beams off manually, pull
the lever backwards @ . The high beam as-
sist is deactivated .
Operating the headlight fla sher
.. To operate the flashe rs while the high beam
assist is active and the high beams are
switched off, pull the lever into posit ion @ .
The high beam assist will remain act ive.
Messages in the instrument cluster
display
Headlight assist: System fault
Drive to your authorized Audi dealer immedi-
ate ly t o have the malfunction corrected. You
can still switch the high beams on or off man-
ually.
Headlight assist : Unavailable. No camera
view
The camera view is blocked, for example by a
sticker or debr is.
The sensor is locat ed between the inter ior
rearview mirror and the w indshield . There-
fo re, do not place any stick ers in this area on
t he windsh ield.
Service setting
There is a different sensit ivity sett ing for serv-
icing . This sett ing can be activated by pressing
and holding the button on the int erior rear-
view m irror for more tha n 18 seconds. The
LED next t o t he button blinks t hree times.
If
you have accidentally select ed this service
function, the origi nal sensitivity will be auto-
matically restored the next t ime you switch
the ignit ion on.
IJ>,
To Next Page
Loading...
