- Turn the electrical equipment off if the
socket has switched off because of over-
heating.
(D Note
- Always fo llow the manufacturer's in-
structions for all electrical accessories
you want to use with the electrical sock-
et!
- Do not connect lamps that contain a ne-
on tube. For technical reasons the lamp
may be damaged.
- Do not connect any 230-volt equipment
to the 115-volt socket . The equipment
may be damaged . If necessary, check the
permissible voltage for the equipment
on the model label.
- In the case of some power packs, e .g. for
a laptop computer, the bu ilt-in overcur-
rent shutoff prevents it from be ing
switched on because of excessive start-
up current. In this case, disconnect the
power pack from the consumer and re-
connect it after about 10 seconds.
@ Tips
- Unshielded equipment may cause inter-
ference in the radio and the veh icle elec-
tronics.
- Some eq uipment may work properly be-
cause of the reduced power (wattage),
available from the socket.
S ea t s a n d s t o rage 69
Folding table in the center console
Applies to vehicles : with fo lding table in the center con-
sole
The folding table is stored in the front area of
the center console.
Fig. 69 Rear cente r con sole : ope ning t he fo lding table
Fig. 70 Rear cente r console: fold ing table inclined po-
sition
Opening
.,. Pull the handle @ back ¢ fig. 69. The fold-
ing table extends out pa rt ially by itself
¢ .&_.
.. Pull the folding table up unti l it locks into
place @ .
.. Fold the tabletop back and down
@.
Storing
.. Release the tabletop @ to fold it back .
.. You can now move the folding table vert ical-
ly back into its original position.
A WARNING
- Do not open the folding tab le while driv-
ing. Opening the folding table while driv-
ing increases the risk of injury in the
event of a collis ion or sudden braking .
- To reduce the risk of pinching, open and
close the folding table carefully and in a
controlled manner .
To Next Page
Loading...
