Programming the buttons
Applies to: vehicles with garage door opener (Homelink)
Fig. 4 1 Head liner: contro l uni t
You can program both fixed code and rol ling code
systems using this procedure.
Programming or reprogramming buttons
• Switch the ignition on.
• Press and hold the button in the roof headliner
that you would like to program for at least
10 seconds. Or
• Se lect: Se lect: ~IC~A~R~lf unction button>
Car sys-
tems
control button > Vehicle settings > Ga-
rage door opener
> Program garage door
opener.
• Follow the instr uct ions in the Infot ainme nt sys-
tem .
Erasing button programming
The programmed buttons cannot be erased indi-
vidually. They must all be e rased toget her. Re-
program the buttons if necessa ry.
• Se lect: ICARI funct ion but t on>
Car systems
contro l bu tt on > Vehicle setting s > Garage
door opener > Clear program settings > Yes.
Displaying the version / status/country code
• Se lect: Se lect: ICARlfunction button> Car sys-
tems
control button > Vehicle settings > Ga-
rage door opener > Version information .
(D Tips
After programm ing the ga rage door opener,
it may be necessary to synchro nize t he motor
wit h the system . Refer t o t he ma nufact urer's
instr uctions.
Open ing and closing
Operation
Applies to: vehicles with garage door opener (Home link)
Requireme nt: The but t ons in the roof headli ner
mus t be programme d
~ page 4 5 and the veh icle
mus t be wit hin range of t he system, such as the
garage doo r opener.
• Press the bu tton to ope n t he garage door. The
LED@ ~
page 45, fig . 41 blink s or tur ns on.
• Press t he bu tton again to close t he ga rage
door.
@ Tips
To ope n or close t he garage do or, pres s th e
button, but do not hold it for longer than
10 seco nd s or t he garage door opener module
will switch to programming mode.
45
To Next Page
Loading...
