Audi Q7 - Button Combinations for Service Personnel; System Reset; Screenshot; Engineering Menu

53
Button combinations for service personnel
System reset
To restart (reset), the following buttons must be briefly pressed at
the same time:
• NAV/MAP (or CAR)
• Rotary pushbutton
• RADIO
Screenshot
When a screenshot is taken, only the image transmitted by the
MMI is saved. The image is saved to the internal memory of the
information electronics control unit 1 J794. To save a screenshot,
the following buttons must be pressed in succession and held
down:
• NAV/MAP (or CAR)
• Rotary pushbutton
The display on the MMI monitor flashes briefly to indicate that the
screenshot has been saved. In total, up to 50 screenshots can be
stored in J794. When the 51st screenshot is saved, the first screen-
shot is deleted.
The saved screenshots can then be copied from J794 to an SD card
using the diagnostic tester. The procedure is as follows:
1. Insert a blank SD card into the left SD card reader (SD1).
2. Select "5F – Basic setting" in the Guided Functions.
3. Start the "Write analysis data to SD card" routine.
The analysis data including the screenshots are now copied to the
SD card.
Engineering menu
To access the Engineering menu, the following buttons must be
pressed in succession and held down:
• NAV/MAP (or CAR)
• MEDIA
Button combination for system reset
Button combination for screenshot
Button combination for the Engineering menu
637_069
637_070
637_071
< Back
Forwards >
Ξ Contents