Heating and cooling 103
Controls Safety Driving tips General maintenance Self-help Technical data
– Press the button for the blower .
– Turn the rotary control to set the blower to the desired
speed (and regulate the volume of air delivery).
The air conditioning system automatically regulates the blower
speed according to the interior temperature. However, you can also
adjust the blower speed manually.
The blower speed will be shown on the MMI display ⇒ fig. 117 for a
few seconds if the MMI is switched on.
Note
• The blower speed may change automatically. This ensures that
the selected temperature is reached as quickly as possible.
• The blower speed cannot be regulated separately for the driver
and front passenger sides of the vehicle.
Applies to vehicles: with deluxe automatic air conditioner plus
Air recirculation mode
The air recirculation setting prevents fumes etc. from
entering the interior.
Switching on the air recirculation mode
– Press the button ⇒ .
Switching off the air recirculation mode
– Press the button again, or
– Press the button, or
– Press the button.
In this setting, the air is drawn from the interior of the vehicle,
filtered and continuously recirculated. We recommend using the air
recirculation mode in the following circumstances:
When driving through a tunnel or in queues of traffic, to prevent
fumes entering the interior of the vehicle.
WARNING
For reasons of safety you should not leave the air recirculation
switched on for too long. This mode prevents fresh air from
entering the vehicle, so the windows can mist over if the air
cooling is switched off. Bad visibility can cause an accident.
Fig. 117 MMI display:
Blower setting
AUTO
document_0900452a81793dcc.book Seite 103 Mittwoch, 21. März 2007 5:42 17
To Next Page
Loading...
