Lights and vision68
Digital compass
Applies to vehicles: with digital compass
Activating and deactivating the compass
The compass direction will appear in the mirror.
– To switch the compass on and off, press and hold
button until the compass display in the mirror
⇒ fig. 69 appears or disappears.
The digital compass only works when the ignition is on. The points
of the compass are displayed as follows: N (North), NE (North East),
E (East), SE (South East), S (South), SW (South West), W (West), NW
(North West).
Note
To avoid inaccurate compass readings, do not hold any remote
controls or other electrical devices or metal objects near the interior
mirror.
Applies to vehicles: with digital compass
Setting the correct compass calibration zone
The correct compass calibration zone must first be set
before the compass can give an accurate reading.
Fig. 70 Map of compass calibration zones
– Press and hold button ⇒ fig. 69 until the currently set
zone number is displayed on the interior mirror.
– Press button repeatedly until the correct zone number
appears. The adjustment mode will be ended automati-
cally after a few seconds.
Fig. 69 Interior mirror:
activated digital
compass
To Next Page
Loading...
