Fuses and bulbs274
Number plate light
Removing number plate light
– Take the screwdriver out of the vehicle tool kit
⇒ page 245.
– Insert the flat-blade side of the reversible screwdriver
insert into the slot on the number plate light ⇒ fig. 261.
– Using the screwdriver, start by pressing the number
plate light to the right -arrow 1- and then pull the number
plate light downwards from this position -arrow 2- and
out of the opening.
– Detach the number plate light.
Changing bulb
– Press the defective bulb out of the bulb holder and fit the
new bulb.
Installing number plate light
– First insert the side with the retaining element ⇒ fig. 262
and then carefully press the number plate light into the
opening.
– Check whether the new bulb is working.
Fig. 261 Boot lid:
Removing number
plate light
Fig. 262 Number plate
light: Retaining
element
document_0900452a81793dcc.book Seite 274 Mittwoch, 21. März 2007 5:42 17
To Next Page
Loading...
