Fuses and bulbs 271
Controls Safety Driving tips General maintenance Self-help Technical data
Changing bulbs
All bulbs can be changed easily after removing the rear
light.
The bulbs are secured with a bayonet fastener. The table
below gives an overview of the bulb positions.
– Remove the relevant bulb holder ⇒ page 266.
– Change the bulb ⇒ page 266.
– Install the bulb holder ⇒ page 266.
– Check whether the new bulb is working.
– Re-install the rear light ⇒ page 271.
Position of bulbs
Installing rear light
The rear light is easy to re-install.
To re-install the rear light, follow the steps for removal in
reverse sequence.
– Plug in the electrical connector. Make sure you hear it
click into place.
– Insert the rear light into the rear light carrier ⇒ fig. 255.
– Press the rear light into the two rubber mountings as far
as it will go. The rear light must be flush with the body
contour.
– Use the screw to secure the rear light from the luggage
compartment.
– Make sure that all bulbs for the rear lights are working.
Caution
Take care when installing the rear light to make sure there is no
damage to the paintwork or any of its components.
Position: ⇒ fig. 254 Bulb function
A Turn signals
B Tail light and brake light
Fig. 254 Position of
bulbs in rear light.
Example: outer left rear
light
Fig. 255 Installing rear
light
document_0900452a81793dcc.book Seite 271 Mittwoch, 21. März 2007 5:42 17
To Next Page
Loading...
