Audient ASP 008 User Manual

5
©audient 05/2008
Operation Manual
Introduction
EARTH This unit is connected via its power cord to the mains safety
earth. NEVER OPERATE THE UNIT WITH THIS EARTH
CONNECTION REMOVED.
COVERS DO NOT remove the covers. Refer servicing to qualified personnel
only.
VOLTAGE ASP008s are set to operate only at the voltage indicated on the
rear panel.CHECK that the correct voltage is available before
connecting the AC mains supply.
FUSES CHECK that the fuse fitted is the correct type for the local mains
voltage. ALWAYS replace fuse with the correct type.
MOISTURE DO NOT expose the unit to rain or moisture. If the ASP008
should become so exposed REMOVE the mains power immediately.
CABLES PROTECT the mains power cord from damage though impact or
abrasion.
HEAT ALWAYS site the ASP008 away from sources of heat including
direct sunlight and ensure adequate ventilation around the unit.
IMPORTANT SAFETY INSTRUCTIONS
RISK OF
ELECTRIC SHOCK
DO NOT OPEN
RISQUE DE CHOC
NE PAS ENLEVER
CAUTION
ATTENTION
WARNING
THIS EQUIPMENT MUST BE EARTHED
DO NOT EXPOSE TO RAIN OR MOISTURE
Please read all of the following instructions and save them
for later reference before attempting to connect the
ASP008 to the AC power source.

Audient ASP 008 Specifications

Audio Specifications

Maximum input level	+21.5 dBu
Maximum output level	+27.5 dBu
Total harmonic distortion	0.007% at 1kHz
Equivalent input noise	-127.5 dB @ 60dB gain/ref 150 ohms
Frequency response	-0.3 dB @10Hz to -3 dB @300kHz at unity gain
Common mode rejection ratio	75 dB at 1kHz and 60dB gain

Power

power consumption	40 watts

Weight and Dimensions

dimensions	480 mm x 278 mm x 44 mm
weight	4.5 kg