Audio Physic Luna - Safety Instructions; Unpacking and Assembly

English High End Series
Safety Instrucons
1. Only use your subwoofer in dry rooms. If any liquids get into your subwoofer, immediately unplug
it and switch o any devices connected to it, for example ampliers, receivers or mul-channel
decoders.
For your safety, take your subwoofer to a specialist, at best an authorised AUDIO PHYSIC dealer,
to be checked.
2. Only use your subwoofer on a stable and level surface.
3. If your subwoofer has been exposed to a cold environment over a long period of me, please
wait unl it has reached room temperature in order to avoid condensaon, which may develop
in the case of sudden and large dierences in temperature and damage the electronics.
4. If you go away or do not plan to use your subwoofer over a long period of me, disconnect it by
unplugging it.
5. Do not leave your subwoofer unaended when in use.
6. Keep your subwoofer, especially the connecon terminals, out of reach of small children.
7. If you want to clean the surfaces of your subwoofer, please switch it o before doing so. Before
switching it back on, please ensure that there is no moisture on the connecon terminals and
that the terminals are securely connected.
8. Your subwoofer should only be opened and, where necessary, repaired by an authorised
AUDIO PHYSIC dealer. Any repairs to or work on your subwoofer that are not carried out by
an authorised AUDIO PHYSIC dealer shall result in a voided warranty. In the case of funconal
problems that cannot be solved or suspected damage to your subwoofer, unplug the device
and take it to your AUDIO PHYSIC dealer to be checked.
Unpacking and Assembly
1. Carefully open the packaging where it has been taped up.
2. Remove the accessory pack from the box.
3. Carefully remove the loudspeaker, together with its protecve foam pads, from the box. It is
ideal if two people carry out this step. Make sure that you do not break o the connecon
terminals or controls when removing and handling the loudspeaker.
4. Now remove the top foam cover and carefully slide down the protecve foil.
5. Stand the subwoofer upside down, preferably on a so surface (carpet or a thick towel) so that
the surface of the cabinet does not get scratched.
6. Screw the spikes supplied with your subwoofer into the threaded inserts in the base and use the
lock nuts to x them in place.
7. Stand your subwoofer the right way up again. Now follow the recommendaons for seng up
your subwoofer in the following chapter.
If you want to further increase the precision and sonic depth of your subwoofer’s
bass response, try out our high-quality VC feet (for example the VCF II M8 feet in
the image on the right). The “Vibraon Control“ feet are not only an alternave
to spikes for high-quality ooring, but also reduce the transmission of vibraons
between the loudspeaker and the oor. The result is an audible improvement to
the device’s realisc sound reproducon. For more informaon and advice,
please contact your dealer.
6