48
Audio device settings
To change the sample rate of the microphone, configure the following settings.
1
Open "Audio Midi Setup" in the "Utilities" folder in the "Applications" folder.
2
Under "Audio Devices", select the product. In the "Input" tab, select the sample rate and bit depth from "Format".
• Two types of the product are displayed, but select the one that shows “AT2040USB 1 in / 0 outs".
• With this product, you can select a sample rate of up to 96 kHz. Selecting a high sample rate may result in high-
quality recorded audio data but will also make these files large.
• For stable recording with less load on the computer, change the sample rate to 48 kHz.
• Match the sample rate to the value set with the recording software. Failing to do so may result in noise.
3
Select the one that shows "AT2040USB 2 (0 ins / 2 outs)" and select the sample rate and bit rate from "Format" in
the "Output" tab as in the operation in step 2.
• Whenever the sample rate of the microphone is changed, the sample rate setting in “Output” or “Input" must
be the same.
Caution
• If the mute indicator lamp is blinking, the sample rate setting differs from that set in the "Output" or
"Input" tab on the Mac you are using. Match the sample rate settings.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
