EasyManua.ls Logo

Audio Technica ATH-SPORT60BT

Audio Technica ATH-SPORT60BT
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
Fully charge the battery when using it for the first time.
When the rechargeable battery is running low, the headphones will play a confirmation tone and voice guidance
notifying you of low battery level, and an indicator lamp will flash in red. When you hear/see these notifications, charge
the battery.
It takes about 2 hours to charge the battery fully. (This time may vary depending on usage conditions.)
1. Connect the included USB charging cable (USB Type-C side) to the product’s battery jack.
The included USB charging cable is designed for exclusive use with the product. Do not use other USB cables.
When inserting the USB charging cable into the USB port or battery jack, insert it directly (horizontally).
Charging in wet conditions should be avoided. Doing so may cause the product to malfunction.
Computer
Battery jack
USB Type-C
USB Type-A
USB charging cable
(included)
USB port
2. Connect the included USB charging cable (USB Type-A side) to the computer to start charging.
While charging, the indicator lamp lights as follows.
Lit in red : Charging in progress
Off : Charging complete
3. When charging is complete, disconnect the USB charging cable (USB Type-A side) from the computer.
4. Remove the USB charging cable (USB Type-C side) from the product’s battery jack.
Charging the battery
If you charge while the product is on, it will turn off. When charging is complete, remove the USB charging cable and
turn on the product again.
When charging, make sure to use the included USB charging cable. The product may not charge with cables other
than the included USB charging cable.

Related product manuals