167
Source Video In
1. Using RG6 Quad shield coaxial cable terminated with male F connectors, connect each of
the Video Source Out Terminals [circle 37] on the AVR21EN Rear Panel to the appropriate
Source Video Input [pentagon 8] on the AVH21 as shown in Figure 93.
2. In larger systems, complete step 1 above by connecting the Video Source Outs [circle 37]
on the AVR21EN to the appropriate Source Video Inputs [pentagon 8] on AVH21 #1 as
shown in Figure 93.
a) Using short lengths of RG6 coax, connect each of the Source Video Output Bypass
Terminals [pentagon 1] on AVH21 #1 to the appropriate Source Video Input
[pentagon 8] on AVH21 #2 as shown in Figure 93.
b) If using three Hubs, connect each of the Source Video Output Bypass Terminals
[pentagon 1] on AVH21 #2 to the appropriate Source Video Inputs [pentagon 8] on
AVH21 #3 as shown in Figure 93.
Camera Video In
1. Using RG6 quad shield coaxial cable terminated with male F connectors, connect each zone
video monitor or security camera composite video output to the appropriate Camera Input
[pentagon 7] on the AVH21. Terminate the camera ends of the coax as appropriate.
2. In larger systems, complete step 1 above by connecting zone video monitor or security
camera composite video output to the appropriate Camera Input [pentagon 7] on AVH21 #1
as shown in Figure 93. Terminate the camera ends of the coax as appropriate.
a) Using short lengths of RG6 coax, connect each of the Camera Video Output Bypass
Terminals [pentagon 3] on AVH21 #1 to the appropriate Camera Video Input
[pentagon 7] on AVH21 #2 as shown in Figure 93.
c) If using three Hubs, connect each of the Camera Video Output Bypass Terminals
[pentagon 3] on AVH21 #2 to the appropriate Camera Video Inputs [pentagon 7] on
AVH21 #3 as shown in Figure 93.
Figure 93 Source and Camera Video
To Next Page
Loading...