88
MASTER ON/OFF ENABLED, an IR emitter must be connected to the Control Out ALL Jack
[circle 35] on the AVR rear panel and attached to the device being controlled (TV/Projector,
Screen, Lights, Curtain) over the IR eye on that device. If more than one emitter is to be used,
connect the Control Out ALL Jack [circle 35] to the IR IN on an amplified IR Connecting Block
and connect the additional emitter.
To configure IR commands for HT MASTER:
Press the Menu Button [oval 44] on the remote to bring the MAIN MENU to the screen. Press
the ▼/▲ Navigation Button [oval 16] so that the cursor is pointed to the REMOTE CONTROL
SETUP line. Press the Set Button [oval 18]. The REMOTE CNTL SETUP 1 screen will appear.
Press the ▼/▲ Navigation Button [oval 16] so that the cursor is pointed to GO TO REMOTE
CNTL 2. Press the Set Button [oval 18]. The REMOTE CNTL SETUP 2 screen will appear.
(Figure 36)
Figure 36 Remote Control Setup 2 Screen
Press the ▼/▲ Navigation Button [oval 16] so that the cursor is pointed to the ASSIGN
TRIGGER OUT line. Press the ◄/► Navigation Button [oval 16] to select the device to be
controlled with a constant 12VDC control voltage.
TRIGGER would typically be used with a TV or Projector that can be turned ON/OFF with a
12VDC signal or a motorized screen that will drop when a 12V signal is present and retract when
the control voltage is removed. Another possible option is a control voltage to a lighting system
that can take a constant 12VDC control signal and convert it to a ‘movie mode’ lighting scene and
then restore normal room lighting when the voltage is removed. NOTE: This function can only be
assigned to ONE device. Once Trigger has been assigned to TV/Projector, Screen or Lighting,
the Trigger setup option will only appear on the setup page for that device. See: Voltage Control
at the end of the TV/Projector, Screen and Lighting sections for configuration.
TV/PROJECTOR ON/OFF
To turn the TV/Projector ON/OFF with the AVR, in the REMOTE CNTL SETUP 2 screen, press
the ▼/▲ Navigation Button [oval 16] so that the cursor is pointed to the TV/PROJECTOR
ON/OFF line. Press the Set Button [oval 18]. The TV/PROJ CONTROL SETUP screen will
appear.
Carrier
With the cursor positioned next to CARRIER, press the ◄/► Navigation Button [oval 16] to
select the proper setting. NOTE: Most IR remotes used with common source components will
have a carrier, so YES should be selected as a first test. Some Cable Box remotes do not use a
carrier, so if a code setting doesn’t work, try changing this setting.
To Next Page
Loading...