185
2. Using the ◄/► Navigation Button [oval 16], set the option for the zone being configured:
YES, NO, ONLY IF ON, ONLY IF OFF.
To exit setup, press the Exit Button [oval 17]. To continue Zone Setup, position the cursor next
to MONITOR THIS ZONE and continue to the next section.
Monitor This Zone
This setting determines whether or not a zone can be ‘listened to’ using the keypad microphone
or ‘viewed’ if the zone being configured has a local video camera installed. Zone Monitoring is
controlled by selecting MONITOR from any keypad’s main menu. When the Monitor button is
pressed, a list of all zones will appear in the keypad’s Information Display [hexagon 13]. When
a zone is selected, a sub-menu of options (AUDIO, VIDEO, AUDIO/VIDEO) will appear. If zone
monitoring has been allowed for a specific zone, one of the three options can be selected. (The
message MONITORED BY KEYPAD X will appear in the Information Display [hexagon 13] on
the keypad of the zone being monitored.)
If NO has been selected in this option the message: CANNOT MONITOR will appear for a few
seconds in the Information Display [hexagon 13] on the keypad in the zone attempting to
initiate Monitor.
If a zone does not have a camera assigned, the message NO CAM ASSIGNED will appear to
inform the user that the system is functioning properly in the absence of a video signal.
To set Monitor This Zone:
1. In the SETUP BY NUMBER PAGE 2 screen, press the ▼/▲ Navigation Button [oval 16] to
position the cursor next to MONITOR THIS ZONE.
2. Using the ◄/► Navigation Button [oval 16], set the permission for the zone being
configured: YES, NO.
To exit setup, press the Exit Button [oval 17]. To continue Zone Setup, position the cursor next
to CAMERA ASSIGNED and continue to the next section.
Camera Assigned
This setting will associate a video camera installed in a particular zone and connected to one of
the Camera Inputs [pentagon 7] on an AVH21, with the Video and Audio/Video Monitoring of
the zone being configured. If the camera installed in the baby’s room (for example Zone 4) is
connected to CAM 4 [pentagon 7] on the AVH21, or AVH21 #1 in systems using multiple AVH’s,
when Zone 4 is being configured, Camera 4 (4) should be selected for this setting. There are 7
camera inputs available for monitoring and there is a NONE option if a zone does not have a
camera installed.
To set Camera Assigned
1. In the SETUP BY NUMBER PAGE 2 screen, press the ▼/▲ Navigation Button [oval 16] to
position the cursor next to CAMERA ASSIGNED
.
2. Using the ◄/► Navigation Button [oval 16], select the camera for the zone being
configured: NONE, 1, 2, 3, 4, 5, 6, 7.
To exit setup, press the Exit Button. To continue Zone Setup, position the cursor next to DOOR
RING and continue to the next section.
Door Ring
Future Feature
To Next Page
Loading...