95
turns off. When the unit turns off, press the ▼/▲Navigation Button [oval 16] to move the cursor
next to: YES. Press the Set Button [oval 18]. This will ‘save’ this code group for ON/OFF control
of the lights.
If no IR ON/OFF commands were found, see Automatic and Learn, below.
If no further programming is required, press the AVR Button [oval 5] on the AVR21ENR1 remote
and then the Exit Button [oval 17] to return to normal operation mode.
To continue in setup, press the ▼ Navigation Button [oval 16] to move the cursor next to: BACK
TO LGT CODE PROG. Press the Set Button [oval 18]. Press the ▼ Navigation Button [oval
16] again to move the cursor next to: BACK TO LGT CNTL SETUP. Press the Set Button [oval
18]. The LIGHTING CONTROL SETUP screen will appear.
To program TV/PROJECTOR ON/OFF, SCREEN ON/OFF, press the ▼/▲Navigation Button
[oval 16] to move the cursor next to: BACK TO REM CNTL SETUP. Press the Set Button [oval
18]. See the TV/Projector and Screen sections.
Lighting Program Code (Automatic)
If ON/OFF codes could not be found by Brand in the Manual Mode, try searching by source type
in the Automatic mode.
In the LIGHTING CODE PROGRAM screen, press the ▼/▲Navigation Button [oval 16] to move
the cursor next to: AUTOMATIC. Press the Set Button [oval 18]. The LIGHTING AUTO
PROGRAM screen will appear.
The SOURCE will be fixed as selected (LIGHTING). Press the ▼ Navigation Button [oval 16] to
move the cursor next to: TRY CODES. Repeatedly press the ◄or►
Navigation Button [oval 16]
to test all selected device type commands until the unit turns off. When the unit turns off, press
the ▼ Navigation Button [oval 16] to move the cursor next to: YES. Press the Set Button [oval
18] to ‘save’ the code group. This will set this code group for ON/OFF control of the Lights.
If no further programming is required, press the AVR Button [oval 5] on the AVR21ENR1 remote
and then the Exit Button [oval 17] to return to normal operation mode.
To continue in setup, press the ▼ Navigation Button [oval 16] to move the cursor next to: BACK
TO LGT CODE PROG. Press the Set Button [oval 18]. Press the ▼ Navigation Button [oval
16] again to move the cursor next to: BACK TO LGT CNTL SETUP. Press the Set Button [oval
18]. The LIGHTING CONTROL SETUP screen will appear.
To program TV/PROJECTOR ON/OFF, SCREEN ON/OFF, CURTAIN OPEN/CLOSE, press the
▼/▲Navigation Button [oval 16] to move the cursor next to: BACK TO REM CNTL SETUP.
Press the Set Button [oval 18]. See the TV/Projector, Screen and Curtain sections.
If a particular brand or functional code from a source type cannot be found in the on-board IR
code Library, IR commands for Lights ON/OFF, or a particular scene, can be taught to the AVR
from the original equipment remote. To teach Lighting ON/OFF or scene codes to the AVR,
proceed to section: Learn Code.
Lighting Program (Learn Code)
To teach the AVR21EN Lighting ON/OFF codes, in the LIGHTING CONTROL SETUP screen,
press the ▼ Navigation Button [oval 16] to move the cursor next to: LEARN CODE. Press the
Set Button [oval 18]. The LIGHTING CODE LEARN screen will appear.
With the cursor positioned next to USING THE ◄/► KEYS line, press the Set Button [oval 18].
The message: USING THE ◄/► KEYS SELECT FUNCTION TO BE PROG
will start to flash,
To Next Page
Loading...