Controls and Functions
-_.- ~..---..,_ .._. . .~ .
POWER
,--.
A2201Q ;
E% :
A2601Q ;
A2801’d s
-pm& :
;,ggg :
A1801Q :
________________________________________----------~---~----~~~-----~---~-----~~
To avoid unwanted ignition noise caused by ground loops, it is essential that the Amplifier
be grounded to a clean, bare, metal surface of the vehicles chassis.
Note: GROUND WIRE SHOULD NOT BE EXTENDED MORE THAN 3 FT (1 METER].
POWER
,--_
A2201Q j
GND REM
/‘BATI ‘\
.___________________--.-----------------------------------~~-----------~---~---,
Due to the power requirements of the Amplifier, this connection should be made directly
to the positive (+)terminal of battery. For safety measure, install an in-line fuse Holder
(not included)as close to the battery positive (+) terminal as possible with an ampere
rating ; not to exceed total value of fuses in Amp.
POWER
,--w
REM
‘WD
I_______________________________________------------------~~---~---~-
To remote wire car stereo.
This amplifier is turned “ON” remotely when vehicle’s stereo is turned “ON”
Note:
IF YOUR RADIO DOES NOT HAVE + 12 VOLT OUTPUT LEAD WHEN THE RALXO IS TURNED ON,
THE ‘REMOTE” TERMINAL ON THE AMPLIFIER CAN BE CONNECTED JO VEHICLES ACCESSORY
C/RCU/T THAT IS LIVE WHEN THE KEY IS “ON”.
Controls and Functions
^- -_-_--- -^
.
I__________________________________
Variable Low-Pass Filter (50Hz-‘I 2OHz) :
filter switch to “LPF”. Adjust variable cr(
The amplifier input circuit filters out ev
adjustment of the frequency control),
Variable Low-Pass Filter (50Hz500Hz) :
filter switch to “LPF”. Adjust variable crt
The amplifier input circuit filters out ev
adjustment of the frequency control),
51
____________________--------------
Variable High-Pass Filter (50Hz-750Hz)
channel, set filter switch to “HPF”. The
below 50Hz . . . . . . . 750Hz.
To Next Page
Loading...
