Version 6.6 19 April 2012
Hardware Installation Manual 4. Mounting the Device
4 Mounting the Device
The device can be mounted in one of the following ways:
On a desktop – see Section 4.1 on page 19
Installed in a standard 19-inch rack – see Section 4.2 on page 20
4.1 Desktop Mounting
The device can be mounted on a desktop, by attaching the supplied four adhesive, anti-
slide rubber feet to the underside of the device. Once you have attached these rubber
bumpers, you can place it on a desktop where the bumpers are in contact with the surface.
Figure 4-1: Underside of Device with Rubber Foot
To apply the anti-slide rubber bumpers to the device:
1. Flip the device over so that its underside faces up.
2. Locate the four anti-slide grooves on the device's underside–one in each of the four
corners, as shown in the figure below:
Figure 4-2: Location of Grooves for Rubber Bumpers
3. Peel off the adhesive, anti-slide rubber bumpers and stick one in each anti-slide
groove.
4. Flip the device over again so that it is resting on its underside and the rubber bumpers
are in contact with the surface.
To Next Page
Loading...
