AudioCodes MediaPack 1288 User Manual

6 | Page
3. DC POWER: For each DC power model, disconnect your DC wires from your DC power source, and
then connect the two DC wires (6-AWG) to the DC terminal block plug (supplied), making sure that the
wires are inserted in to the correct openings on the terminal block according to their polarity (negative
or positive). Insert the DC terminal block plug into the DC inlet of the Power Supply module, located on
the rear panel. Connect the DC power leads to a 48-VDC power source.

AudioCodes MediaPack 1288 Specifications

General

Brand	AudioCodes
Model	MediaPack 1288
Category	Gateway
Language	English