To Next PageTo Next Page
Need help?Do you have a question about the AudioControl ACM-2.300 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Minimum Impedance Unbridged | 2 Ohms |
| Minimum Impedance Bridged | 4 Ohms |
| THD+N | < 0.1% |
| Fuse Rating | 30 A |
| Power at 2 Ohms | 300 W |
| Bridged Power at 4 Ohms | 600 W |
| Frequency Response | 20 Hz - 20 kHz |
| Crossover | 12dB/octave |
| Signal to Noise Ratio | > 100dB |
Fuse rating and replacement instructions.
Connects to the +12V battery binding post using recommended wire gauge.
Connects to the 12V remote trigger or uses GTO™ signal sensing for turn-on.
Connects to a good ground connection on the vehicle chassis.
Connects speaker outputs from other amps/radios via a 4-conductor plug.
Connects line-level outputs from head unit or radios for audio signals.
Connects speaker wire to loudspeakers; minimum impedance 2 Ohms stereo or 4 Ohms bridged.
Power LED indicates status; Protection LED shows diagnostic codes for problems.
Turns amplifier on/off with audio signal; can be bypassed for 12V remote.
Selectable 12 dB/Octave Linkwitz-Riley crossover points at 80 Hz, 120 Hz, or bypass.
Adjusts the overall volume output level; counterclockwise decreases, clockwise increases.
Indicates when the amplifier gain has been maximized for optimum performance.
