To Next PageTo Next Page
Need help?Do you have a question about the AudioControl LC-4.800 and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| S/N Ratio | > 100 dB |
| Input Impedance | 20 kOhms |
| Minimum Load Impedance | 2 Ohms |
| Fuse Rating | 30A |
| AccuBASS | Yes |
| GTO Signal Sense | Yes |
| Signal to Noise Ratio | > 100 dB |
| Power at 2 Ohms | 200 Watts |
| Frequency Response | 20 Hz - 20 kHz |
| THD+N | <0.01% |
| THD | <0.01% |
| Crossover | 12dB/octave |
| Power at 4 Ohms | 100 Watts x 4 |
| Bridged Power at 4 Ohms | 400 Watts |
Adheres to warnings regarding installation, electrical shock, and hearing protection.
Enables/disables AccuBASS® and ACR-1; controls output levels and bass restoration.
Gain controls output levels; MILC™ LED prevents clipping; Gain Maximized LEDs indicate peak performance.
Enables/disables AccuBASS® and ACR-1; controls output levels and bass.
Gain control, AccuBASS® Threshold/Level, MILC™ Source Clip LED, Gain Maximized LEDs.
Connect power, ground, remote, audio inputs, and loudspeakers with quality cables.
Connect head unit's +12V trigger output to amplifier's remote input for turn-on.
Connect factory radio speaker-level outputs to amplifier's speaker-level inputs.
Connect 2-channel audio device line-level outputs to amplifier's line-level inputs.
Detailed technical specifications including power output, frequency response, and dimensions.
Explanation of Power (Blue) and Protection (Red) LED codes for diagnostics.
