To Next Page
R
Ricky SuttonAug 11, 2025
What to do if AudioControl ARCHITECT MODEL 2660 Amplifier has no sound?
- KKathryn KruegerAug 11, 2025
If your AudioControl Amplifier isn't producing sound, here are a few things to check: * Ensure the Power LED is blue. * Make sure the Protection LED is off. * Confirm the Zone Status LED is blue. * Verify there is a wire link between the +12V pin and the Trigger Input pin of the Master Trigger 3-pin connector block. * Confirm the source unit is operating. * Check the speaker connector plugs on the rear panel. * Unplug the power cord and check the AC Power Fuse on the rear panel.
General
