5
carefully take it out.
MP3-CD PLAYBACK
This player is capable of MP3-CDs. It takes longer time for this player to read an MP3-CD than it
does CD-DA. Wait patiently while it is reading. After an MP3-CD is successfully read, the icon of
“MP3” shows on the display with the total number of albums and tracks. And a second later,
playback begins from the first track of the first album.
Note:
z To ensure good system performance; wait until the disc tray completely reads the disc
before proceeding.
z If no disc is loaded into the compartment, or the disc is placed upside down, the display will
show “ NO DISC ”.
SELECTING A DESIRED TRACK/PASSAGE
To select a desired track
Press the SKIP UP /DOWN button repeatedly in the stop mode or during play until the desired
track appears on the display.
To search for a particular passage during playback (track scanning at high speed)
Press and hold the SKIP UP /DOWN button to scan the current playing track at high speed until
desired point passage, and then release the button.
Playback will start again from this point.
To select a song which track number exceeds 10 (for MP3 disc only)
To select a song/track which number exceeds 10, Press the +10MP3/ALBUM button each time
to skip forward 10 tracks, then press the SKIP UP /DOWN button to select desired track.
To Select A Desired Folder (for MP3 disc only)
(if the MP3 disc contains more than one folder)
Press and hold the +10MP3/ALBUM button more than 2 second, the album number will flash,
press SKIP UP/DOWN to select the desired album then press PLAY/PAUSE/SD button to begin
playing the first track of the selected album ; press the SKIP UP/DOWN button to select the
exact track you are going to listen to.
PROGRAMMED TRACKS
Programmed tracks of disc are possible when playback is stopped. Up to CD 20 tracks /MP3 99
tracks can be stored in the memory in any order.
1. In the stop mode,with CD disc, press the PROG./P-MODE button, the Ā000ā will flash and
the
P01 will shown on the display.
2. Press the CD SKIP UP/DOWN button to select the first desired track to be programmed.
3. Press the PROG./P-MODE button to enter. The display changes to show
P02.
4. With MP3 disc, press the CD SKIP UP/DOWN button to select the desired album, press the
PROG./P-MODE button to enter; Press the CD SKIP UP/DOWN button to select the first
desired track to be programmed.
5. Repeat steps 2 & 3 to store other desired tracks for CD until all tracks are programmed.
Repeat steps 3 & 4 for MP3.
6. Press the PLAY/PAUSE/SD button to start playback from the first programmed track.
7. Press the STOP/USB button to stop program playback.
To Erase the Memory (Program)
To clear the program, you have two options:
1. Press the STOP/USB button when the disc is stopped, or
2. Open the CD compartment lid, program will be erased.
To Next Page
Loading...