Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one
wider than the other. A grounding plug has two blades and a third grounding prong. The wide blade or the third prong
is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of
the obsolete outlet.
Protect the power cord from being walked on or pinched particularly at the plugs, convenience receptacles, and at
the point where they exit from the apparatus.
Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the
apparatus. When a cart or rack is used, use caution when moving the cart/apparatus combination to avoid injury from
tip-over.
Unplug this apparatus during lightning storms or when unused for long periods of time.
Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any
way, such as power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus,
the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
CAUTION: These servicing instructions are for use by qualified service personnel only. To reduce the risk of electric
shock, do not perform any servicing other than that contained in the operating instructions unless you are qualified to
do so.
Do not install this equipment in a confined or built-in space such as a bookcase or similar unit, and keep well
ventilated in open space. The ventilation should not be impeded by covering the ventilation openings with items such
as newspaper, table-cloths, curtains etc.
WARNING: Only use attachments/accessories specified or provided by the manufacturer (such as the exclusive
supply adapter, etc).
WARNING: Please refer to the information on the exterior panel of the enclosure for electrical and safety information
before installing or operating the apparatus.
WARNING: For the terminals marked with symbol of “ ” may be of sufficient magnitude to constitute a risk of electric
shock. The external wiring connected to the terminals requires installation by an instructed person or the used of
ready-made leads or cords.
WARNING: This product takes the power plug as the disconnecting device, may maintain the convenient operation
when using.
This label tells you that the unit contains a laser component. Opening the unit will expose the
user to radiation from the laser beam.
The apparatus with CLASS I construction shall be connected to a MAINS socket outlet with a protective earthing
connection.
Mains Supply: The mains operating voltage of Audiolab 6000 series units is shown on the rear panel. If this voltage
does not match the mains voltage in your area, consult your Audiolab dealer about converting the unit.
The mains supply fuse on the rear panel is accessible when the IEC mains plug has been removed. In the rare event
that it has broken, check for any obvious cause before replacing the fuse with one of the correct rating and type.
The fuse values are:
220 – 240V (UK, China, etc.) T630mAL 250V Slow Blow100 – 120V (USA, Japan, etc.) T1 AL 250V Slow Blow
To Next Page
Loading...
Need help?
General
