Audiolab 6000CDT Instruction Manual

Fitting Batteries
The remote control requires 2 x AAA type batteries. Due to international shipping and courier regulations with Lithium
Ion batteries, the remote controller batteries are not included in this package.
Always use AAA batteries and replace them in sets -never mix old and new batteries.
Handset Operation
The handset operates several Audiolab components. The handset buttons shown crossed out are for use with other
Audiolab units and are not operational when used with the 6000CDT.
Point the handset at the remote receiver and press the relevant key. The handset should be within 15 meters ofthe
player and there must be a clear line of sight between the two units.
Connections
Digital Outputs
Coaxial and Optical output
One Coaxial and one Optical SPDIF digital output. Connect a suitable Digital coaxial

Audiolab 6000CDT Specifications

General

Transport Type	Slot-loading
Digital Outputs	1 x Coaxial, 1 x Optical
Power Consumption	15W
Disc Compatibility	CD, CD-R, CD-RW
Output Impedance	75 Ohms
Sampling Rate	44.1 kHz
Standby Power Consumption	<0.5W
Frequency Response	20Hz - 20kHz