Audionet WATT - Page 34

34
Important
• First, you have to select the input channel that is dedicated to the By-Pass
mode before you are able to use the By-Pass mode.
• For security reasons none of the input channels is selected for By-Pass mode
by factory default (
By-Pass Mode disabled
).
• You cannot select input IN 4 , ('
Phono Input
') as input for the By-
Pass mode.
The By-Pass mode is primarily intended to integrate the overwhelming sound
quality of the WATT into an existing home cinema setup or to expand an existing
excellent stereophonic system based on the WATT to a complete home cinema
setup without missing the qualities of the WATT. To implement this kind of
setup, please proceed as follows:
1. Connect you home cinema preamplifier according to its user's manual.
2. Do not connect its front channel Left and Right outputs to the power amplifier
but to one of the free inputs , , respectively , , of the WATT.
3. Use menu item
By-Pass Channel
at the setup menu of the WATT to
select the input channel for By-Pass mode, which you just connected to the
outputs Left and Right of the home cinema preamplifier.
4. Connect all high quality 2-channel sources to the remaining inputs of the
WATT.
5. Connect your DVD player to your home cinema preamplifier as usual.
Use the WATT to listen to high quality 2-chanel sources. If you would like to use
your home cinema system, activate the By-Pass mode of the WATT and use your
home cinema preamplifier as usual.