Need help?Do you have a question about the Audiotec Fischer PP 62DSP and is the answer not in the manual?
General| Brand | Audiotec Fischer |
|---|---|
| Model | PP 62DSP |
| Category | Amplifier |
| Language | English |
Instructions for safe and proper installation of MATCH components to prevent damage or injury.
Guidelines for connecting the PP 62DSP amplifier to a 12V negative ground vehicle system.
Connector for a passive MATCH PP subwoofer.
Control for adjusting the input sensitivity of the highlevel inputs.
Indicator that lights up red if an analog input is overdriven.
Connector for the MATCH cable harness; use original cable.
Connects the PP 62DSP to your PC for configuration.
Button to toggle between setups or initiate a device reset.
Indicates amplifier operating mode and selected setup.
For uploading vehicle specific setups to the PP 62DSP.
Remote input/output for amplifier turn-on/off and external amp control.
Switches functionality of optional URC remote control's MODE switch.
Multifunction interface for accessories like remote controls.
Activates/deactivates remote control functionality.
Outputs for connecting external amplifiers, use Rem Out for turn-on.
Output for passive subwoofers; recommend direct 12V source connection.
Adjusts input sensitivity up to 6 dB for low output signals, not a volume control.
Lights red when highlevel inputs are overdriven; reduce sensitivity to turn off.
Use only the included harness or MATCH accessories; avoid others to prevent damage.
Connect to PC via USB for DSP PC-Tool software configuration.
Toggles between two memory areas; 5-sec press erases memory.
Indicates operation mode (green/orange) or undervoltage (red). Flashing red means no setup.
Copy car-specific setups from MicroSD card to amplifier memory.
Remote input/output for amplifier turn-on/off and external amp control.
Configures MODE switch for URC remote control (toggle radio/MEC or original/DSP setup).
Connects accessories like remote controls; activation via RC Control switch or PC-Tool.
Activates/deactivates URC remote control functionality, primarily with car-specific setups.
Floating-ground lowlevel outputs for additional amplifiers; use Rem Out for turn-on.
Reduces power consumption when no signal is present for over 60 seconds.
ADEP circuit protects against OE radio errors and feature loss.
Easily configure DSP via MicroSD card without a PC.
Steps to access website, download setup, and transfer to MicroSD card.
Steps for connecting the MATCH PP 62DSP to the car radio via the cable harness.
Powering the PP 62DSP via the car radio harness, checking wire gauge and fuse.
Connecting directly to the car battery for power if harness supply is insufficient.
How to adjust input sensitivity using the potentiometer for optimal signal input.
How to activate/deactivate the automatic turn-on feature via the 'Automatic Remote' switch.
Steps to download, install, and connect the amplifier to the PC for configuration.
Using the DSP PC-Tool software for amplifier configuration and important initial settings.
Step-by-step guide to install an optional MATCH Extension Card (MEC) into the amplifier.
To Next Page
