⑷ Setup parameters
Heating power: Numerical according to material and working surroundings. General
between 10 and 30.The bigger of numerical the better of peeling effect, but printing speed will
slow. Exceed numerical will burn print medium even the print head.
Temperature control: Current version does not support 3.01,keep default.
Walking speed: The bigger of numerical the slower of equipment operation speed.
But too small numerical can cause the data lost, numerical recommendation bigger than 5.
Hollow-out print: Currently not support to 1.09 version.
Repetition time: Print times of same content. For example input 10 if the files should
be printed 10 times. Note that numerical should bigger than 1 or device will automatically stop .
Output filename: Save the name of your printed file.
Immediately output: When you select this option click "OK" after above
parameters were set and equipment can be normal operation.
Equipment storage: Choose your storage device when net is connected according
to your equipment on the mainboard storage devices. If equipment on the mainboard connect
To Next Page
Loading...
General