Need help?Do you have a question about the AUMA SQR 12.2-F12 and is the answer not in the manual?
General| Brand | AUMA |
|---|---|
| Model | SQR 12.2-F12 |
| Category | Controller |
| Language | English |
Provides fundamental safety guidelines and standards for product operation.
Explains the meaning of safety signals like DANGER, WARNING, CAUTION, and NOTICE.
Instructions for engaging and disengaging manual operation of the actuator.
Covers local and remote operation of the actuator via its motor.
Details the standard and optional features and functionalities of the actuator.
Details the information found on the actuator's name plate and its components.
Instructions for attaching the actuator to the valve using a coupling.
Provides fundamental safety and general information for electrical connections.
Details the connection procedure using AUMA plug/socket connectors.
Step-by-step guide for connecting cables, including sheathing and wire preparation.
Critical safety warnings regarding hazardous voltage and protective earth connection.
Explains the status bar and navigation support elements within the display.
Details feedback indications for valve position, direction, and end positions.
Shows how torque applied at the actuator output is indicated on the display.
Details status indications like Warnings (S0005), Not Ready REMOTE (S0006), and Fault (S0007).
Details status indications based on NAMUR recommendation NE 107.
Explains S0011 indication for failures, showing count and circle with cross symbol.
Explains the arrangement and meaning of standard and optional indication lights.
Describes the use of output contacts for sending status signals and their assignment.
Instructions for setting the actuator's internal end stops to limit the swing angle.
Step-by-step guide to set the CLOSED end position for the actuator.
Instructions for setting the OPEN end position, noting it may not always be required.
Guides on setting the seating type (Limit or Torque) with valve manufacturer consent.
Instructions for setting torque limits to protect the valve from overload.
Guide to setting trip torque for OPEN and CLOSE directions, including password entry.
Instructions for setting the actuator's limit switches for OPEN and CLOSED positions.
Instructions to perform a test run after all settings have been completed.
Procedure to verify the correct direction of rotation of the actuator.
How to verify if the limit switching has been set correctly.
Lists common faults during commissioning and their remedies.
Explains display indications for faults, warnings, and status signals.
Faults indicating torque limits were exceeded during CLOSE or OPEN operation.
Indicates motor protection tripping due to overheating.
Lists primary fuses (F1/F2, F3, F4) for the power supply unit and internal DC supply.
Step-by-step instructions for replacing fuses F1/F2, F3, and F4.
Explains motor protection mechanisms (PTC thermistors/thermoswitches) and fault signals.
Lists required measures for safe operation and maintenance, including inspections and tests.
To Next Page
