Need help?Do you have a question about the AUMA SQ 07.2 and is the answer not in the manual?
General| Brand | AUMA |
|---|---|
| Model | SQ 07.2 |
| Category | Controller |
| Language | English |
Provides fundamental information on safety and compliance with standards.
Details the information found on the actuator and control name plates.
Describes the procedure for mounting the actuator to the valve.
Provides step-by-step instructions for mounting the actuator to the valve using a coupling.
Provides essential basic information and warnings for electrical connection.
Details the SD electrical connection using the AUMA plug/socket connector.
Provides instructions for connecting cables, including terminal cross sections and torques.
Details how to connect fieldbus cables, including board variants and switch functions.
Explains how to operate the actuator manually for setting and commissioning purposes.
Covers the procedures for operating the actuator via the electric motor.
Explains how to operate the actuator locally using the control unit's push buttons.
Details how to operate the actuator remotely via fieldbus.
Explains how to navigate menus and settings using the local controls' push buttons.
Explains the information displayed in the status bar and navigation support.
Details how actuator and valve positions are indicated on the display.
Explains the arrangement and meaning of the indication lights on the local controls.
Explains the function and setting of internal end stops for part-turn actuators.
Provides detailed steps for setting the CLOSED end stop.
Provides detailed steps for setting the OPEN end stop.
Explains how to set the valve seating type (limit or torque).
Details settings for fieldbus address, baud rate, parity, and monitoring time.
Explains how to set the torque switching limits for valve protection.
Details how to set the limit switching for recording travel and operating switches.
Step-by-step guide for setting the CLOSED end position using limit switches.
Step-by-step guide for setting the OPEN end position using limit switches.
Explains how to set intermediate position switches for each running direction.
Instructions for setting intermediate positions for the CLOSE running direction.
Instructions for setting intermediate positions for the OPEN running direction.
Covers the procedure for performing a test run after settings are completed.
Details the EWG 01.1 electronic position transmitter and its technical data.
Describes the potentiometer used as a travel sensor and its settings.
Provides instructions for setting the potentiometer for valve position sensing.
Details the RWG electronic position transmitter and its technical data.
Explains how to set the measuring range for the RWG electronic position transmitter.
Lists common faults encountered during commissioning and their remedies.
Explains fault and warning indications shown on the display and their meaning.
Provides instructions for replacing fuses, emphasizing safety precautions.
Step-by-step guide for replacing fuses F1/F2, including safety warnings.
Instructions for testing and replacing fuses F3/F4.
Diagram and list of spare parts for part-turn actuators SQ/SQR series.
Diagram showing spare parts for AC 01.2 actuator controls with SD electrical connection.
Provides a detailed list of spare parts for AC 01.2 actuator controls.
To Next Page
