AUMA SAEx 07.2 User Manual

Control
Parallel
Profibus DP
Profinet
→ Modbus RTU
Modbus TCP/IP
Foundation Fieldbus
HART
Multi-turn actuators
SAEx 07.2 – SAEx 16.2
SAREx 07.2 – SAREx 16.2
Control unit - electromechanical
with actuator controls
ACExC 01.2 Intrusive
Assembly and commissioningOperation instructions

AUMA SAEx 07.2 Specifications

General

Brand	AUMA
Model	SAEx 07.2
Category	Controller
Language	English

Summary

Safety Instructions

Safe Handling Prerequisites

Essential requirements for safe product operation and installation.

Transport, Storage, and Assembly

Assembly Procedures

Steps for mounting, output drive types, and accessories.

Electrical Connection

Basic Connection Information

Connection Types (KT/KM, KP/KPH, KES)

Details on different plug-in connection types and terminal compartments.

Fieldbus and Earth Connections

Operation

Manual Operation Procedures

Procedures for operating the actuator manually via handwheel.

Motor Operation (Local & Remote)

Operating the actuator using local controls and remote commands.

Menu Navigation and User Levels

Indications and Status Display

Display Indications Overview

Status bar, navigation support, valve position, and operation commands.

Status Codes (AUMA & NAMUR)

Basic Commissioning and Settings

Seating Type and Fieldbus Configuration

Configuring seating type, fieldbus address, baud rate, and monitoring time.

Torque, Limit, and Intermediate Position Setup

Adjusting torque, setting end/intermediate positions, and rotation checks.

Test Run Procedures

Corrective Actions and Faults

Commissioning Faults

Troubleshooting common issues encountered during initial setup.

Fault and Warning Indications

Interpreting display indications for faults, warnings, and status codes.

Fuses, Motor Protection, and Fault Types

Servicing and Maintenance

Preventive Maintenance Measures

Disconnecting from Mains