To Next PageTo Next Page
Need help?Do you have a question about the AUMA SAEx 10.2 and is the answer not in the manual?
General| Explosion protection | ATEX, IECEx |
|---|---|
| Motor voltage | 24V DC, 110V AC, 230V AC, 400V AC, 480V AC |
| Housing material | Aluminum alloy |
| Protection class | IP68 |
| Input signals | Analog 4-20mA, 0-10V; Digital signals |
| Output signals | Digital signals |
| Communication interfaces | Profibus DP, Modbus RTU, Foundation Fieldbus |
| Power supply | 24V DC, 110V AC, 230V AC, 400V AC, 480V AC |
| Type of actuator | Electric multi-turn actuator |
Requirements for safe handling, including directives and guidelines.
Explains hazard signal words (DANGER, WARNING, CAUTION, NOTICE) and symbols used.
Step-by-step guide for mounting the actuator to the valve.
Details the KT/KM electrical connection type and its properties.
Explains how to operate the actuator manually for setting and emergency purposes.
Covers operating the actuator using the motor.
Guides users on navigating menus using push buttons for settings and viewing indications.
Explains various indications shown on the actuator's display, including status bars and feedback signals.
Instructions for setting the actuator's type of seating (limit or torque).
Procedure for setting the torque switching limits for overload protection.
Instructions for setting the limit switches for end positions OPEN and CLOSED.
Guidelines for performing a test run after settings are complete.
Details the EWG 01.1 electronic position transmitter and its technical data.
Covers the RWG electronic position transmitter and its technical data.
Lists faults that may occur during commissioning and their remedies.
Explains fault and warning indications displayed by the actuator controls.
