EasyManua.ls Logo

auna iTuner 320 ME - Page 70

auna iTuner 320 ME
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
70
EN
The rst two alarms are similar to the normal alarm. Turn the power on,
set the current time, and then set how often the alarm should ring. You
can choose between “daily“, “once“ and “on specic weekdays“.
Set the corresponding values by turning the volume control or pressing
the buttons on the remote control. Press the button , to move
to the next input eld. Press the OK button on the remote control or the
volume control to conrm.
Set the desired alarm tone. You can choose between beep, melody and
Internet radio (DAB/ FM/ USB).
Once an alarm is set, the icon appears on the screen next to the
current time.
Note: If you have selected “Internet Radio“ (DAB/ FM/ USB) as the alarm
tone, a favourite stored station will be played. Only the same station can
be set for Alarm 1 and Alarm 2. Once the set alarm time is reached and
the alarm tone is “Internet Radio“, the unit will connect to the Internet if
the network is available. Therefore there may be a short delay between
the set alarm time and the actual playing of the radio station. If no
network connection is available at that time, the unit will automatically
switch to “Melody“. If you have activated the NAP alarm, the alarm
will ring every 5/ 10/ 20/ 30/ 60/ 90/ 120 minutes, depending on your
setting.
To adjust the alarm volume, select “Alarm Volume“.
Once the alarm(s) has/have been set, the alarm icon will be displayed
at the bottom of the screen. The alarm icon with time display is also
displayed on the screen in standby mode.
To stop the alarm, press the standby button. To activate the snooze
mode, press the SLEEP button on the unit or the button
on the
remote control. The alarm will sound again after only 5 minutes.

Table of Contents

Related product manuals