auna iTuner 320 - Page 78

78
EN
• When PBC Wlan setup is selected, the unit will scan the available
wireless network.
• When View settings is selected, you can check the "Active connection",
"MAC address", "Wlan region", "DHCP", "SSID", "IP address", "Subnet
mask", "Gateway address","Primary DNS" and "Secondary DNS".
• When Wlan region is selected, refer to page 57 point 6.
• When Manual settings is selected, the screen will appear as below.
NetRemote PIN Setup
>
>
Connection type
Wired
Wireless
DHCP
DHCP enable
DHCP disable
BKSP
OK
CANCEL
0 1 2 3 4 5 6
7 8 9
NetRemote PIN Setup
>
>
Connection type
Wired
Wireless
DHCP
DHCP enable
DHCP disable
BKSP
OK
CANCEL
0 1 2 3 4 5 6
7 8 9
• If Wired is selected, the screen will appear as below.
• Select "DHCP enable", when "Waiting for Ethernet" appear on screen,
please insert the wire cable head into the LAN port until the connection
is successful.
• Select "DHCP disable" to enter IP settings to set the IP address and
Subnet mask.
• When NetRemote PIN Setup is selected, then enter the 8-digit code.
• The unit generates an 8-digit code number which you enter the wireless
router, access point