auna KR-140 - Page 28

28
EN
button to conrm the minute time set and go for CT on/o set, the “Ct
On” or “Ct OF” will blinking;
• Rotates again the “Adjustment (16)” button to “ -” or “+ ” for selecting
the “Ct On” or “Ct OFF” as you desired;
• Short press again the“Adjustment (16)”button to conrm.
• The clock set adjustment is completed and clock time is showing on
LED display.
Information for CT on/o function:
• By design, the BT Kitchen Clock Speaker will be sync once the clock
time at 2:00 (AM) by every mid night. This function is for keeping the
clock time is up-to-date.
• The CT function for clock’s time sync can be turn o and on as you
desired, however clock’s time cannot be sync and update when it is in
disabled mode.
Alarm 1 / Alarm 2 and Wake-Up function
Alarm time set
• Short press the “ALARM (13)” button to entry the set alarm function, rst
the Alarm 1 symbol (
) will blinking.
• Then short press the “ALARM (13)” button again can switch to when
you want; (Short press this button can switch in between and
repeatedly.)
Set Alarm 1 for example
• Short press the “ALARM (13)” button to choose
.
• Then short press the “Adjustment (16)” button to conrm and go for set
alarm’s hour, and the number of alarm hour will blinking;
• Rotates the “Adjustment (16)” button to “ -” or “+ ” for selecting the
desired hour of Alarm 1. Short press the “Adjustment (16)” button to
conrm and go for set minute of Alarm 1. The number of minute will
blinking.
• Then again, rotate the “Adjustment (16)” button to “ -” or “ +” for
selecting the desired minute of Alarm 1 and short press the “Adjustment
(16)” button to conrm and go for choose wake-up source. The “bU”
letter will blink on LED display.
• Rotate the “Adjustment (16)” button to position “ -” or “ +” for choosing
“bU” or “tU” which as want. The wake-up source could switch from “bU”
to “tU” repeatedly if continually rotates it button to “ -/+ ”