Auping K2 - 3. Preparing for use; 3.1 Components of your mesh base; 3.2 Installing the electric motor

■ Use an Auping K2 mesh base in
combination with an Auping mattress.
■ Only place the bed in a dry room. In view of
the electrical components it is not
permitted to place the bed in a damp room.
■ Make sure that the cables cannot become
trapped. Check this by adjusting the bed
after it has been installed.
■ Remove the plug from the socket during a
thunderstorm.
3. Preparing for use
3.1 Components of your mesh base
- Auping K2 mesh base.
- Electric motor with remote control.
3.2 Installing the electric motor
1. The head support motor is already factory-
mounted on the mesh base.
2. Attach the back motor (151747) to the
underside of the mesh with the screw and
locking pin, as shown in the diagrams.
3. Attach the upper leg motor (151748) to the
underside of the mesh with the screw and
locking pin, as shown in the diagrams.
GB14
151747 / 151748
151747 151748
_006IH_3114 BW.pdf - pag.14
November 9, 2007
LET OP !!! Lage resolutie!