4. Use
4.1 Electrically adjustable sections
The handset is used to adjust the electrically
adjustable sections (see fig. 7).
1. Raise head support
2. Lower head support
3. Raise back section
4. Lower back section
5. Raise foot end
6. Lower foot end
7. Raise head support, back section
and foot end
8. Lower head support, back section
and foot end
Press one of the 'up' or 'down' buttons, holding
it down until the desired position is reached.
Only one button can be operated at a time.
5. Breakdowns
While an electrical fault may be a nuisance, it
is not dangerous. The motor is fitted with all
necessary safety provisions and has double
insulation.
5.1 Electrical malfunctions
Check that:
- the plug is in the socket;
- the current is switched on at the mains.
5.2 Mechanical malfunctions
Undesirable noises (bed squeaks and creaks)
Unwanted noises are usually caused by moving
parts touching each other.
The reason for this may be a missing part, or
parts that have not been tightened up properly
or have become loose when the bed was
moved.
Check that:
- the bed is properly horizontal;
- the bed is positioned away from the wall;
- there are no unwanted objects in the bed that
should not be there (spoons, forks, pens, etc.).
GB17
fig. 7
_006IH_3114 BW.pdf - pag.17
November 9, 2007
LET OP !!! Lage resolutie!
To Next Page
Loading...