12
IMPORTANT!
Setting the delays starts with the speaker farthest from the listening position
(usually the subwoofer).
The farthest speaker does not need any additional delay.
The remaining speakers should be adjusted according to the difference between
the distance from the farthest speaker and the distance from the target speaker
to the listening position.
For example: the distance from the listener to the subwoofer is 220cm,
the distance from the listener to the front left tweeter is 80cm.
The delay for the left tweeter channel will be: 220cm - 80cm = 140cm.
We enter the number 140 into the channel delay value of the left tweeter.
Make the necessary calculations for all speakers, then make settings in the
AURA AUDIO app or in the receiver menu.
Position - listener position selection.
All / Front left / Front right / Front all.
Delay - value for each channel.
Select the desired channel and set the desired signal delay value.
In MONO mode, the delay values for 7/8 channels will be adjusted synchronously.
Gain - signal level value for each channel.
Select the desired channel and set the required signal level.
In MONO mode, the levels for 7/8 channels will be adjusted synchronously.
DTA reset
Reset delay settings.
Delay units
Selecting a unit of measurement: centimeters or milliseconds.
Car type
Select car type: Sedan / Station wagon / Minibus.
DTA SETTING
To Next Page
Loading...
