Aurora AU1630MA - Installation Guide; Unit Setup and Placement; Installation Caution

4 ENGLISH
INSTALLATION
PaperShredder
OperatingInstructions
Installation
Operation
Maintenance
Troubleshooting
Service Center
Limited Warranty
*ONEFOLDEDSHEETOFPAPEREQUATESTO2SHEETSOFPAPER
Heavier paper, humidity or other than rated voltage may reduce shredding capacity.
Sheet Capacity
Paper Shred Size
Paper Entry Width
CD/Credit Card Capacity
Duty Cycle
Voltage
16 Sheets of 20 lb. bond paper*
5/32 in. x 15/32 in. pieces
0.4 cm x 1.2 cm pieces
8.7 in / 220 mm
1 at a time
10 min. on / 45 min. off
120V~60Hz / 3.0 A
1. Make sure the basket door is securely closed shut. This shredder features a safety power cut off and
will not operate if door is open. Shredders with pull-out wastebaskets feature a safety power cut off
upon bin removal. The supplied wastebasket activates this switch, which allows the shredder to be
operable.
2. Attach all 4 caster wheels to the bottom of the wastebasket. (FIGURE 1)
3. A socket-outlet should be near the equipment and be easily accessible.
4. Connect the power cord to any standard 120 volt AC outlet.
Microcut shredders have very sharp exposed blades on the underside. Do not touch. Unplug the
shredder before clearing paper jams.
Use care when mounting the shredder on the wastebasket.
FIGURE1
PUSH
DOWN
PUSH
DOWN
!
Caution:
CORRECT FIT
OPERATION