Page | 22
Care Advice
External Paint
The external surface requires regular maintenance in the same way as your vehicle. Only use mild,
ammonia free detergents paired with a non-abrasive wash pad or sponge to wash the camper.
Only use wax-based polishes, do not use cutting compounds or abrasive pastes. These will leave
scratches and may expose the base material.
Corrosion Protection
Australia has some of the most beautiful areas to explore, but unfortunately these areas are also
the most harsh on your vehicle and trailer. Water crossings and beach driving are some of the
harshest areas that your trailer will be used and without proper maintenance, your trailer will
suffer. It is important that after any water crossing or beach driving that the trailer is thoroughly
cleaned, top to bottom, including a flush to the chassis.
After all uses of the trailer, it is important to complete a full clean, inside, and out to keep
everything at tip top condition.
Products like Lanotec, WD40 and Inox do a great job of protecting the metal surfaces of the trailer,
it is important to use these regularly on the fittings of the trailer.
Condensation/Mould
Condensation is a normal part of living in Australia, and this is highlighted when camping. The
temperature difference inside and outside a camper can be quite significant, and with the moisture
in the Australian air and the smaller living area of a camper, condensation can build up overnight.
While this can be quite disconcerting, it is totally normal. Ensure that there is sufficient air flow in
the camper to allow the moisture to escape overnight.
If you do encounter a build up of condensation in the camper, make sure to air this out in the
morning to avoid the moisture building up in the soft furnishings, especially mattresses.
It is recommended to place moisture absorbing tubs in the camper especially when it is in storage
and change these out on a regular basis to avoid mould growing.
To Next Page
Loading...