Page | 10
Country Comfort Hot Water System
The Simpson camper comes with the Country Comfort portable LPG hot water system as a standard
inclusion. This is designed to work with the gas and water fittings on the drawbar of the camper to
provide a hot shower for use in the ensuite.
The Country Comfort hot water system is activated by water pressure, without water pressure it will
not operate. You need to ensure that the water tank being drawn from is full enough to provide a
consistent flow of water to the hot water system.
Full user manual and instructions can be found in the box or here,
https://countrycomfortwaterheater.com.au/collections/shower-packages/products/country-
comfort-portable-lpg-water-heater
Inside the hot water system box you will find hoses and fittings to connect the hot water system to
the water connection on your drawbar. There will not be a gas hose inside the box, the hose required
to connect the hot water system is in the draw under the stovetop of your slide out kitchen.
All adjustments and maintenance must only be carried out by an authorised person. The
installation of all gas and combustions appliances MUST comply with the standards in force.
Carbon Monoxide warning - This appliance is designed for outdoor use only and must be used
in well ventilated areas. Use in enclosed areas, including inside the camper annex, may result in
injury or death.
Accessible parts of the Country Comfort hot water system may be very hot, keep young
children away.
Preparing the hot water system for use
1.Remove the heater along with all the components from the box and place them on a table in front
of you. Notice that there is a gas input, hot water output, cold water Input as well as a battery box.
To Next Page
Loading...