Page | 11
2. Insert two ‘D’ batteries into the ‘battery box’ and close the battery box lid. Note: The orientation of
the battery terminals. Positive down at the back. Negative down at the front.
For garden hose water supply use, install a male garden hose attachment to allow for a ‘snap on’
connection (not supplied) to a garden hose. First, install a reducer fitting to increase the ‘water
input’ size from ½” to ¾” to suit the ‘quick fitting’ attachment. Male quick fitting hose adaptor
(supplied)
3. Wrap the ‘water input’ thread with two rotations of Teflon tape before installing the reducer
fitting. Tighten the adaptor, taking care not to over tighten as this could break or crack the inlet
pipe. Finally, connect the male garden hose attachment.
4. Shower hose and rose: Check that the seal is secure in both ends of the flexible shower hose.
Attach the shower rose to the flexible shower hose using the conical end fitting. Hand force only. Do
not over tighten.
To Next Page
Loading...