Page | 20
Gas System
The Simpson is fitted with plumbed gas, with the gas cylinder holder mounted inside the front stone
guard. The gas hose has the LCC27 connection and requires the matching gas cylinder to be able to
use the system.
Once the gas cylinders are connected, you can connect the external 2 burner stove top to the
mounted bayonet fitting using the attached hose. Once the stove top is connected, turn on the gas
cylinder. The control knob for the stove top needs to be turned to the high position and held in whilst
pressing the ignition switch. It can take up to 2 mins for the gas to flow to the burner from the gas
cylinders. Once the burner has lit, continue holding the control knob down for a further 5 secs to
ensure it stays lit.
When travelling the gas supply MUST be turned off, and it is recommended to purge the lines of gas
before travel.
• Light the external kitchen gas burner
• Turn off the gas cylinder in the front storage box
• Allow the burner to go out
• Wait until the burner is touch cool before closing the kitchen
To Next Page
Loading...