Description of the MSC
AUTEC - Air Series 2 LIIMSC0AE0-03.fm
A8 - Configuration Menu
MSC
Description of the MSC
The MSC radio remote control's working mode is used to enter the installation menus.
It is possible to enable/disable the MSC either by acting on the receiving unit or by acting on the transmitting unit.
The SERVICE CONTROL programming can only enable the MSC mode if it is enabled as a factory setting. Therefore, the
MSC mode can only be enabled after making sure that it is activated (ON) by checking this in the technical data sheet.
When the radio remote control is in MSC, pressed pushbuttons do not activate the receiving unit's outputs.
Disable the MSC mode to start controlling the machine again.
Enabling/disabling the MSC through the receiving unit
Enabling the MSC
To enable the MSC, do the following.
1. Remove power from the receiving unit.
2. Open the receiving unit and set DIP switch 2 on the mother board to ON.
3. Close the receiving unit and power it.
At the next radio remote control's start up, the green LED in the transmitting unit and the ENABLE LED in the receiving unit
blink twice per second, indicating that the radio link has been built and the radio remote control is in MSC mode.
Disabling the MSC
To disable the MSC do the following.
1. Remove power from the receiving unit.
2. Open the receiving unit and set DIP switch 2 on the mother board to OFF.
3. Close the receiving unit and power it.
At next radio remote control start-up:
- the green LED in the transmitting unit blinks slowly, indicating that the radio remote control is ready to control the ma-
chine
- the ENABLE LED in the receiving unit blinks, indicating that the radio link is built.
MSC
Mode of Service Control
To Next Page
Loading...
