AUTEC AIRTR08LM - Enabling;Disabling MSC via Transmitting Unit

LIIMSC0AE0-03.fm 3 AUTEC - Air Series
A8 - Configuration Menu
Enabling/disabling the MSC through the transmitting unit
MSC
Enabling/disabling the MSC through the transmitting unit
Enabling the MSC
To enable the MSC do the following with the transmitting unit switched off and the STOP pushbutton released.
Disabling the MSC
To disable the MSC do the following with the transmitting unit switched off and the STOP pushbutton released.
STARTFUNCT.
1
2
34
R
G
STOP
S1 S2
STARTFUNCT.
1
2
34
R
G
STOP
S1 S2
1
2
34
R
G
ENABLE
1
2
34
R
G
STOP
1R
2
34
G
S1 S2
PIN
1
2
34
R
G
STARTFUNCT.
Keep pushbuttons S2 and
START pressed until the
green LED illuminates
Enter the PIN
code
Press pushbutton S1
repeatedly until LED 2
blinks
Keep pushbuttons
FUNCTION, START and S2
pressed until the green LED
is steady on to save
this setting
Transmitting unit off STOP pushbutton released
At the next radio remote con-
trol's start up, the green LED
in the transmitting unit and
the ENABLE LED in the
receiving unit blink twice per
second, indicating that the
radio link has been built and
the radio remote control is in
MSC mode.
NOTE
STARTFUNCT.
1
2
3
4
R
G
STOP
S1 S2
STARTFUNCT.
1
2
3
4
R
G
STOP
S1 S2
1
2
3
4
R
G
DISABLE
1
2
3
4
R
G
PIN
STARTFUNCT.
1
2
3
4
R
G
STOP
S1 S2
1
2
3
4
R
G
Keep pushbuttons S2 and
START pressed until the
green LED illuminates
Enter the PIN
code
Press pushbutton S1
repeatedly until LED 1
blinks
Keep pushbuttons
FUNCTION, START and S2
pressed until the green LED
is steady on to save
this setting
Transmitting unit off STOP pushbutton released
At next radio remote control
start-up:
- the green LED in the trans-
mitting unit blinks slowly,
indicating that the radio
remote control is ready to
control the machine
- the ENABLE LED in the
receiving unit blinks, indi-
cating that the radio link is
built.
NOTE