WORKING FREQUENCY
AUTEC - Air Series 4 LIIWFR1AE0-03.fm
A8 - Configuration Menu
WORKING FREQUENCY
Programming procedures provided hereafter allow to set the radio remote control's radio link features; these must
comply with the laws and standards enforced in the market where they are used. In order for the system “machine+ra-
dio remote control” to be compliant and therefore to be used, it shall comply with such laws and standards: if it does
not, the system may be stopped and impounded by competent supervisory bodies.
Autec cannot be held responsible if the radio remote control is set with forbidden frequencies.
Programming related to “Working frequency” is as follows:
- BANK GROUP.
The BANK GROUP programming is used to set the frequency bank used by the radio remote control.
- RADIO MODE.
The RADIO MODE programming is used to choose the automatic scan mode or the manual selection of frequency.
- CHANNEL BANK.
The CHANNEL BANK programming is used to choose the working frequency.
It is only possible to enter the BANK GROUP, RADIO MODE and CHANNEL BANK programming if the radio remote control
is in MSC working mode (Mode of Service Control).
When the setting procedure has ended, disable the MSC mode to start controlling the machine again.
Write down all changes in the technical data sheet.
Enter the programming related to the BANK GROUP, RADIO MODE and CHANNEL BANK programming without modifying
the setting to check options set through those procedures.
Leaving programming without modifying settings
You can leave any programming in any moment without modifying the settings; do as follows:
1. press the STOP pushbutton
2. wait approx. 10 seconds without pressing any pushbutton.
WORKING FREQUENCY
To Next Page
Loading...
