AUTEC Dynamic Series User Manual

Working
AUTEC Dynamic Series
LIDYNE00-02.fm Part A: Description, warnings and instructions
A - 19
ENG
As the radio remote control address is stored in the S-KEY, use it with ut-
most care to reduce risks that may result from incorrect handling.
If the main transmitting unit cannot be used because it has been lost or
damaged, the back-up transmitting unit can be used instead. In this case,
insert the S-KEY in the back-up unit. The back-up unit is identical to the
main unit; the only difference is the presence of the plate “BACK-UP UNIT”
on the battery housing.
6.3 START pushbutton
6.4 STOP
The STOP pushbutton should be pressed when it is necessary to stop the
machine immediately when a dangerous condition should occur.
When the STOP pushbutton is pressed, the machine stops
(active stop: see paragraph 1.5.1), and the transmitting unit
switches off.
To start working again after the STOP pushbutton has been
pressed:
1. make sure that the working and usage conditions are
safe
2. turn the STOP pushbutton in the arrow direction to un-
lock it
3. start up the radio remote control (see paragraph 5.1).
6.5 Command meaning
Commands on the transmitting unit are established according to the machine's
operations and functions. They are established by the machine manufacturer,
who also chooses the symbols used.
The START pushbutton is used to:
- start up the radio remote control (see paragraphs 5.1,
5.4 and 5.5)
- activate the horn when the radio remote control is start-
ed.

AUTEC Dynamic Series Specifications

General

Brand	AUTEC
Model	Dynamic Series
Category	Remote Control
Language	English