To recharge a flat battery, proceed as
follows:
1. Insert the battery into its proper
battery charger, which should be
positioned in an area having a
temperature of between +5°C and
+35°C. The battery now starts charging,
a state signalled by the lighting up of the
“ON CHARGING” pilot light.
After a maximum of 4÷5 hours the
"END OF CHARGE" indicator switches
off: the battery is fully charged. Remove
the battery from the charger (if the battery
is not removed, charging continues in
maintenance mode).
2.
CHARGING THE BATTERY
The transmitting unit should be switched off each time
work is stopped by turning the ignition key to "O" and
extracting it (always put the key in a safe place).
The unit may also switch off if the battery is not sufficiently
charged and/or when the radio remote control is not used for
more than 7 minutes.
SWITCHING OFF
Page 10
LIE16MU1
To Next Page
Loading...
Need help?
General
