8.6 Enabling switch
A three-position actuator, called "Enabling switch", can be present on the left side of the
Transmitting Unit.
The "Enabling switch" is an actuator that needs to be activated at the same time as other
actuators in order to consent to send the corresponding commands to the Machine. The
Manufacturer and/ or the Installer decide which actuators need to have the "Enabling switch"
activated to send commands to the Machine.
A
A
A Enabling switch
These are the three possible positions for the "Enabling switch":
1. not pressed (OFF),
2. half pressed (ON),
3. completely pressed (OFF).
The "Enabling switch" is only activated when it is in position "2".
When you release the "Enabling switch" from position "3", you will skip position "2" and go
directly to position "1".
NEVER USE TAPE, ELASTIC BANDS OR OTHER OBJECTS TO INTERFERE
WITH THE OPERATION OF THE "ENABLING SWITCH". DOING SO COULD
DAMAGE THE UNIT, PREVENTS THE PROPER FUNCTIONING OF THE UNIT
AND COULD CAUSE SERIOUS INJURY OR DEATH, AND/OR PROPERTY
DAMAGE.
The "Enabling switch" can only be associated to the enabling function to
activate other commands, and cannot be connected to any other start up
or movement function of the Machine.
26
LIULK6N03_eng-00
General operating instructions
AUTEC - AIR SERIES
To Next Page
Loading...
Need help?
General
