8.11.2 PIN code start up (no power keyswitch)
When the Receiving Unit is correctly powered on, perform the following procedure; press
each pushbutton within 3 seconds after releasing the previous one:
1. Insert a charged battery in the Transmitting Unit (see paragraph 8.7.1),
2. press the START pushbutton and hold it down until the green LED illuminates,
3. activate the commands corresponding to PIN code in the correct sequence (PIN 1, PIN
2 and PIN 3 given in the Technical Data Sheet).
a. PIN 1 shall not be included in the start up procedure if it coincides with the START
pushbutton.
b. PIN 3 shall not be included in the start up procedure if it coincides with the START
pushbutton.
4. press the START pushbutton and hold it down until the green LED blinks quickly.
5. release the START pushbutton.
When the green LED blinks slowly, the Radio Remote Control is active and it can send
commands and activate the Machine.
Note: default PIN code set by AUTEC is:
- PIN 1=START pushbutton.
- PIN 2=FUNCTION pushbutton.
- PIN 3=START pushbutton.
Autec will set a customized PIN code only upon request by the Machine
Manufacturer or the Installer.
8.11.3 Power keyswitch + PIN code start up
When the Receiving Unit is correctly powered on, perform the following procedure; press
each pushbutton within 3 seconds after releasing the previous one:
1. Insert a charged battery in the Transmitting Unit (see paragraph 8.7.1),
2. insert the power keyswitch in the Transmitting Unit (see paragraph 8.1.3),
3. press the START pushbutton and hold it down until the green LED illuminates,
4. activate the commands corresponding to PIN code in the correct sequence (PIN 1, PIN
2 and PIN 3 given in the Technical Data Sheet).
a. PIN 1 shall not be included in the start up procedure if it coincides with the START
pushbutton.
b. PIN 3 shall not be included in the start up procedure if it coincides with the START
pushbutton.
5. press the START pushbutton and hold it down until the green LED blinks quickly.
6. release the START pushbutton.
When the green LED blinks slowly, the Radio Remote Control is active and it can send
commands and activate the Machine.
AUTEC - AIR SERIES
General operating instructions 31
LIULK6N03_eng-00
To Next Page
Loading...
Need help?
General
